Quick Release Bicycle Aluminum Alloy Bike Plate, Seat Mountain Bike, Rear Rack, Clothes Hanger

Weight: 1.1kg Size: The length of the shelf surface is 55CM, the width is 14.5CM, and the support feet can be adjusted to a height of approximately 35-45CM. Advantages: Quick detachable, lightweight, with reflective tail lights, including side wings (guardrails), with elastic rope, adjustable front and rear position of shelves, adjustable height of support feet Material: Strong all aluminum alloy Applicable vehicle models: 24 "-29" bicycles with a seat diameter of 33mm or less, suitable models include Giant Wild, ATX, XTC series, and many mainstream mountain bikes such as Merida Warrior and Duke series can be installed. Most DAHON bicycles have seat tubes with a diameter greater than 35MM, while SP8 and other models have tubes that are too thick to install. Accessories: 6 screws, 6 nuts, 6 washers, 4 small washers, 4 large washers. 4 rubber pads, 2 detachable side wings, 2 sliding rods, and 1 telescopic support frame Frequently Asked Questions: 1. Why can't the screw be screwed in halfway? Answer: Because it is an anti slip nut with an rubber ring inside, there may be a phenomenon where it cannot be turned halfway, but as long as it is turned hard and the rubber ring is punctured, it can be done. This type of screw is not easy to slip out as long as it is installed, which is safe. 2. How much weight can this shelf carry? This shelf is currently one of the quick release shelves on the market that is both sturdy and has a load-bearing capacity. The manufacturer's conservative load-bearing data is below 25KG, but in reality, it exceeds this data.